SCSI

Home ] Nach oben ] Inhaltsverzeichnis ]


Monitorservice

Ersatzteile

Elektronik-Forum

Gästebuch

 Webhosting  

Reparaturen

Ersatzteilversand

Für Fachhändler

Ersatzteilbeschaffung  

Ein Vogel

SCSI

aus der comp.periphs.scsi-FAQ:
_____________________________________  _____________________________________
| SCSI  |         | MINI  |         |  | SCSI  |        | MINI  |          |
| SIGNAL| DD-50P  | MICRO | DD-50SA |  | SIGNAL| DD-50P | MICRO | DD-50SA  |
------------------------------------  -------------------------------------
| -DB(0)|    2    |  26   |   34    |  |  GND  |    1    |   1   |    1    |
| -DB(1)|    4    |  27   |    2    |  |  GND  |    3    |   2   |   18    |
| -DB(2)|    6    |  28   |   19    |  |  GND  |    5    |   3   |   35    |
| -DB(3)|    8    |  29   |   36    |  |  GND  |    7    |   4   |    3    |
| -DB(4)|   10    |  30   |    4    |  |  GND  |    9    |   5   |   20    |
| -DB(5)|   12    |  31   |   21    |  |  GND  |   11    |   6   |   37    |
| -DB(6)|   14    |  32   |   38    |  |  GND  |   13    |   7   |    5    |
| -DB(7)|   16    |  33   |    6    |  |  GND  |   15    |   8   |   22    |
| -DB(P)|   18    |  34   |   23    |  |  GND  |   17    |   9   |   39    |
|  GND  |   20    |  35   |   40    |  |  GND  |   19    |  10   |    7    |
|  GND  |   22    |  36   |    8    |  |  GND  |   21    |  11   |   24    |
|  RSR  |   24    |  37   |   25    |  |  RSR  |   23    |  12   |   41    |
|TERMPWR|   26    |  38   |   42    |  |  OPEN |   25    |  13   |    9    |
|  RSR  |   28    |  39   |   10    |  |  RSR  |   27    |  14   |   26    |
|  GND  |   30    |  40   |   27    |  |  GND  |   29    |  15   |   43    |
| -ATN  |   32    |  41   |   44    |  |  GND  |   31    |  16   |   11    |
|  GND  |   34    |  42   |   12    |  |  GND  |   33    |  17   |   28    |
|  BSY  |   36    |  43   |   29    |  |  GND  |   35    |  18   |   45    |
| -ACK  |   38    |  44   |   46    |  |  GND  |   37    |  19   |   13    |
| -RST  |   40    |  45   |   14    |  |  GND  |   39    |  20   |   30    |
| -MSG  |   42    |  46   |   31    |  |  GND  |   41    |  21   |   47    |
| -SEL  |   44    |  47   |   48    |  |  GND  |   43    |  22   |   15    |
| -C/D  |   46    |  48   |   16    |  |  GND  |   45    |  23   |   32    |
| -REQ  |   48    |  49   |   33    |  |  GND  |   47    |  24   |   49    |
| -I/O  |   50    |  50   |   50    |  |  GND  |   49    |  25   |   17    |
----------------------------------------------------------------------------

 * NC = NOT CONNECTED

 CONNECTOR TYPES:
                                  DD-50SA
                        ________________________            MINI-MICRO
       DD-50P          |   -------------------  |      _____________________
    ______________     |17 \o o o o o o o o o/1 |     |  _________________ |
 49| o o o o o o |1    | 33 \ o o o o o o o /18 |     |25\ o o o o o o o /1|
 50| o o o o o o |2    |  50 \o o o o o o o/ 34 |     | 50\o o o o o o o/26|
   ---------------     |      -------------     |     |   --------------   |
                       --------------------------     ----------------------

Vorsicht, der DD-50SA wird nicht nur für SCSI benutzt, bei einer
SUN3/260 und bei DEC dient er zum Anschluss von MFM/RLL-Platten! (Danke
an michael@cubic.org für den Hinweis.)

(VIEWED FROM FACE OF CONNECTOR -  USE VENDOR NUMBERING SYSTEM AS SPECIFIED)

 o Termination: The Single Ended electrical class depends on very tight
termination tolerances, but the passive 132 ohm termination defined in 1986
is mismatched with the cable impedance (typically below 100 ohms). Although
not a problem at low speeds when only a few devices are connected,
reflections can cause errors when transfer rates increase and/or more
devices are added. In SCSI-2, an active terminator has been defined which
lowers termination to 110 ohms and is a major boost to system integrity.

 o Bus Arbitration, Parity and the Identify Message were options of SCSI,
but are required in SCSI-2. All but the earliest and most primitive SCSI
implementations had these features anyway, so SCSI-2 only legitimizes the de
facto market choices. The Identify message has been enhanced to allow the
target to execute processes, so that commands can be issued to the target
and not just the LUNs.

 o Connectors: The tab and receptacle microconnectors chosen for SCSI-2 are
available from several sources. A smaller connector was seen as essential
for the shrinking form factor of disk drives and other peripherals. This
selection was one of the most argued over and contentious decisions made
during SCSI-2 development.
          

 

 

ATX Steckerbelegung ] PC-Periferie ] Parallel ] Rechner-Rechner ] Modem ] MIDI ] [ SCSI ] Netzwerk ]

Home ] Nach oben ] Inhaltsverzeichnis ]

 

 




Brock, Radio und Fernsehen  Inhaber : Baldur Brock
Großgartacher Str. 180  74080 Heilbronn
Tel : 07131 920256   Fax : 07131 910915  E-Mail : Baldur.Brock@fernseh-werkstatt.de
Eingetragen in der Handwerksrolle der Handwerkskammer Heilbronn


Forum für Ersatzteile und Reparaturen an Haushaltsgeräten und Unterhaltungselektronik

Ersatzteile     Laugenpumpe     Servicewerkstatt Ersatzteilversand     Ersatzteilversand     Ersatzteilversand für Fernseher

Hier verwendete Produktbezeichnungen, Logos und Abbildungen sind Eigentum des jeweiligen Herstellers oder Besitzers und dienen lediglich zur Identifikation!